Mitel 5324 IP - Manual (Page 24)

5312/5324 IP Phones User Guide
To add a call on Hold to an existing conversation or conference:
1. Press the AddHeld softkey.
2. Press the flashing line key.
Swap
To call another party when you are in an established two–party call:
1. Press (TRANS/CONF).
2. Dial the number.
To alternate between the two parties:
 Press
the Swap/Trade feature key or the Trade softkey.
Call Forward
Call Forward lets you redirect incoming calls to an alternate number. You can select one of
the following forwarding options:
 Always redirects all incoming calls regardless of the state of your telephone.
 B–Int redirects internal calls when your telephone is busy.
 B–Ext redirects external calls when your telephone is busy.
 NA–Int redirects internal calls after several rings if you don't answer.
 NA–Ext redirects external calls after several rings if you don't answer.
Note: For information about "I'm Here?", see Call Forward – Remote.
To program Call Forward:
1. Press (APPLICATIONS).
2. Press # or the No softkey until "Call Forwarding?" appears.
3. Press * or the Yes softkey .
4. Press # or the Next softkey until the type of Call Forward that you want to set up appears
(see above).
5. On a 5324 IP Phone only, press * or the Review softkey.
6. If a number is already programmed, press * or the Change softkey .
7. Press * or the Program softkey .
8. Dial the destination number.
If you make an error while dialing, press * or the  softkey to correct errors.
9. Press (DOWN) or the Save softkey.
- 18 -