MIDLAND 74-250 Owner Manual - Manual (Page 9)

9
• From the clock display:
1. Press and release the “FUNC/SNOOZE” once to change from
clock to alert display.
• You will see on the display in most cases “NO
MESSAGE” scrolling across the screen. This message will
depend on if you have received any alerts recently. Above
the message you will see on the right center of the display
“
COUNTY ” followed by a number (1-9) (as described
earlier). This number is the county/channel location
presently in use.
2. Press and hold “SET” button until you see six digits on the
display. The number next to the word “ COUNTY ” will flash.
 The six numbers are the county (fips) code. Refer to the
instructions above on how to acquire the FIPS code
2. Press the “UP” button to select the county code/memory
location you desire (1-9). This number will flash indicating
you are able to change that digit.
There are nine county code/channel memory locations
available. Each location can have a different county code
and channel if desired.
4. Press and release the set button. The first digit of the county
code will flash indicating you are able to change that digit.
Each press of the “SET” button will allow you to change
each digit with the “UP/DOWN” buttons on the side of the
radio. The digits will flash indicating you can change that digit
5. Press and release the “UP/DOWN” buttons to change the
digit.
6. Press and release the “SET” button to move to the next digit.