beautypg.com

General information, Supplied accessories, Acknowledgement – Motorola FW-C155 User Manual

Page 7: Environmental information, Safety information

background image

7

English

General Information

This product complies with the radio
interference requirements of the European
Community.

Supplied accessories

– 2 speaker boxes
– remote control
– AM loop antenna
– FM wire antenna

Acknowledgement

Energy Star
As an ENERGY STAR

R

Partner, Philips has
determined that this product
meets the ENERGY STAR

R

guidelines for energy efficiency.

Environmental information

All unnecessary packaging has been omitted.
We have tried to make the packaging easy to
separate into three materials: cardboard (box),
polystyrene foam (buffer) and polyethylene (bags,
protective foam sheet).

Your system consists of materials which can be
recycled and reused if disassembled by a
specialised company. Please observe the local
regulations regarding the disposal of packaging
materials, exhausted batteries and old
equipment.

Safety information

● Before operating the system, check that the

operating voltage indicated on the typeplate (or
the voltage indication beside the voltage
selector) of your system is identical with the
voltage of your local power supply. If not, please
consult your dealer.

● Place the system on a flat, hard and stable

surface.

● Place the system in a location with adequate

ventilation to prevent internal heat build-up in
your system. Allow at least 10 cm (4 inches)
clearance from the rear and the top of the unit
and 5 cm (2 inches) from each side.

● Do not expose the system, batteries or discs to

excessive moisture, rain, sand or heat sources
caused by heating equipment or direct sunlight.

● The lens may cloud over when the system is

suddenly moved from cold to warm
surroundings, making it impossible to play a disc.
Leave the system in the warm environment until
the moisture evaporates.

● The mechanical parts of the set contain self-

lubricating bearings and must not be oiled or
lubricated.

When the system is switched to Standby

mode, it is still consuming some power.
To disconnect the system from the
power supply completely, remove the AC
power plug from the wall socket.