Basic functions, Demonstration mode, Switching the system on – Motorola FW-C155 User Manual
Page 13: Switching the system to standby mode, Dim mode
13
English
Demonstration mode
The system has a demonstration mode that
shows the various features offered by the system.
To activate the demonstration
● In standby mode, press and holdÇon the
system until "
WELCOME" is displayed.
➜ The demonstration will begin.
To deactivate the demonstration
● Press and holdÇon the system until
"
DEMO OFF" is displayed.
➜ The system will switch to standby mode.
Note:
– If you have not deactivated the demonstration,
it will resume five seconds after the system
switches to Eco Power standby or standby mode.
Switching the system on
In standby/demonstration mode
● Press STANDBY ON to switch on the last
selected source.
● Press CD 1/2/3, TUNER or
TAPE (TAPE 1/2).
● Press OPEN/CLOSE.
➜ The system will switch to CD mode.
In Eco Power standby mode
● Press ECO POWER to switch on the last
selected source.
● Press CD 1/2/3, TUNER or TAPE 1/2 on the
remote control.
Switching the system to standby
mode
In demonstration mode
● Press and hold Ç on the system.
In any other source mode (except Eco
Power standby mode)
● Press STANDBY ON (or B on the remote
control).
➜ The clock will appear on the display when the
system is in standby mode.
Switching the system to Eco
Power standby mode (< 0.5 Watt)
● Press ECO POWER (or press and hold B on
the remote control).
➜ "
ECO PWR" is displayed, then the display
screen will go blank.
➜ The low power ECO POWER LED will be
lighted.
Dim mode
You can select the desired brightness for the
display.
● In any source mode (except standby mode),
press
DIM MODE repeatedly to select : DIM 1,
DIM 2, DIM 3 or DIM OFF.
➜
DIM
is shown, except for DIM OFF mode.
DIM
mode
1
2
3
OFF
Brightness
normal
half
half
normal
Spectrum
Analyser
off
on
off
on
Note:
– In standby mode, pressing DIM MODE to select
half or full brightness for clock display.
Basic Functions