McIntosh Audio Control Center C45 - Manual (Page 8)

8
Rear Panel Connections
Connect the power
cord to a live AC
outlet. Refer to in-
formation on the
back panel of the
C45 to determine
the correct voltage
External KEYPAD
or Sensor Jack per-
mits the con-
nection of a McIn-
tosh Keypad or IR
Sensor for remote
operation POWER CONTROL and Trigger Outputs send
Turn-On signals to other components connected
to the C45. The MAIN Jacks send the signal
when the C45 is switched On. The ACC POWER
CONTROL sends a turn On/Off signal to other
components using the Remote Control or
preselected in Setup. The SETUP Feature in the
C45 allows the MAIN(A) and ACC(B) Power
Control Jacks to be re-assigned to Switch On
when the desired Input Source is selected.
VCR and TAPE
Record Outputs
contain the sig-
nals for making
a recording
VCR, TAPE, SAT,
DVD, CD2, CD,
TUNER unbalanced
INPUTS accept high
level program source
signals
PH/AUX accepts high
level program source
signals or signals from
a Moving Magnet
Phono Cartridge. The
SETUP feature deter-
mines whether the Input
Jacks are set for AUX
or PHONO
Ground
connection
for turntables
Balanced Main
OUTPUTS contain
the program signals
for all six channels
DATA PORTs send signals
to compatible source compo-
nents to allow remote con-
trol operation IR INPUT for
connecting an
IR Receiver
Unbalanced Main
OUTPUTS contain
the program signals
for all six channels
BALANCED
INPUTS for a
two channel
component
source
Unbalanced 6 CHANNEL
INPUT Number 2 for signals
coming from a six channel
component source
Unbalanced 6 CHANNEL
INPUT Number 1 for signals
coming from a six channel
component source