McIntosh Audio Control Center C45 - Manual (Page 15)

15
How to Operate the Setup Mode
Your McIntosh C45 has been factory configured for default
operating settings that will allow immediate enjoyment of
superb audio without the need for further adjustments. If
you wish to make changes to the factory default settings, a
Setup Feature is provided to customize the operating set-
tings using the Front Panel Alphanumeric Display.
1. Press the POWER Switch to ON, the Red LED above
the STANDBY/ON Push-button lights to indicate the
C45 is in Standby mode. To switch On the C45 press
the STANDBY/ON Push-button. Refer to figure 3.
2. Press the C45 Front Panel SETUP Push-button. The
LED above the SETUP Push-button will illuminate and
the Front Panel Display will indicate DISPLAY 10. Re-
fer to figure 1.
Note: The Front Panel Display will indicate DISPLAY 10
the first time, after that it will display whatever
Setup Mode was last accessed.
3. Press TONE BYPASS (Menu) Push-button and notice
that with each press of the push-button, the Setup Mode
advances through ten different possible adjustment se-
lections and one informational display.
Note: If the optional TM1 AM/FM Tuner Module is
installed into the C45 there will be 2 additional
adjustments relating to the TM1.
4. To exit from a specific Setup Mode, press the SETUP
Push-button a second time. The LED above the SETUP
Push-button will extinguish and the Front Panel Display
will revert back to its normal display. Refer to figure 2.
The following listings indicate the default settings without
the optional TM1 AM/FM Tuner Module installed and the
page number for instructions on how to change a setting:
Setup Function Name
Setting Page Number
Display (Brightness) 10 16
Version (C45 Firmware) C45 _ . _ _ 16
Input 2 *TUN 17
Level (Input Trim) 0.0 17
6 Channel 1 (Input) Off 18
6 Channel 2 (Input) Off 18
Balanced (Input) Off 18
2Ch Sub Off 19
Trig Tun -- 19
AutoTone Off 19
Remote (Control Type) Norm 20
The following listings indicate the default settings with the
optional TM1 AM/FM Tuner Module installed and the page
number for instructions on how to change a setting:
Setup Function Name
Setting Page Number
Display (Brightness) 10 16
Version (C45 Firmware) C45 _ . _ _ 16
Country Code _ _ _ _ _ _ 16
Tune - > Tune 16
Input 0 *TUN 17
Level (Input Trim) 0.0 17
6 Channel 1 (Input) Off 18
6 Channel 2 (Input) Off 18
Balanced (Input) Off 18
2Ch Sub Off 19
Trig Tun -- 19
AutoTone Off 19
Remote (Control Type) Norm 20
Default Settings
Figure 1
Figure 2
Figure 3
Setup