Meco 6623S8E641 User Manual

Page 25

How to Perform A Leak Test “FIRST TIME USE” and as required

Supplies Needed for a Leak Test:

• Clean paint brush

• Water

• Dish washing liquid

1. Use an LP Gas Cylinder equipped with an OPD (Overfill Prevention Device) and have it filled at an authorized LP

gas dealer by a qualified attendant.

2. Make sure all grill Control Panel Knobs are turned to the “Off” position and verify that the LP Gas Cylinder valve is

closed by turning the knob on the LP Gas Cylinder clockwise until it stops.

3. Mix one part of water with one part of dish washing liquid.

4. With the regulator hose connected to the LP Gas Cylinder, turn the knob on the Cylinder counterclockwise. (Fig. 1)

Fig. 1

Fig. 2

Coupling

Nut

Check for leaks at

Cylinder Valve and

Regulator Connection

and Fittings

5. Check for leaks by brushing the soap solution on all gas valves, hose connections and fittings. (Shown by the heavy

arrows in Fig. 2 & 3) Make sure you generously brush the locations with the soap solution, completely surrounding
the connections and fittings.

Fig. 3