Metrologic Instruments IS6520 - Manual (Page 34)

27
A PPENDIX B
Default Settings
Many functions of the scanner can be "programmed" - that is, enabled or
disabled. The scanner is shipped from the factory programmed to a set of
default conditions. The default parameter of the scanner has an asterisk (*) in
the charts on the following pages. If an asterisk is not in the default column
then the default setting is Off or Disabled. Every communication does not
support every parameter. If the communication supports a parameter listed in
the charts on the following pages, a check mark will appear.
Parameter Default RS-232* Light Pen
UPC/EAN * a a
Code 128 * a a
Code 93 * a a
Codabar a a
Interleaved 2 of 5 (ITF) * a a
MOD 10 Check on ITF a a
Code 11 a a
Code 39 * a a
Full ASCII Code 39 a a
MOD 43 Check on Code 39 a a
MSI-Plessey a a
MSI-Plessey, 10/10 Check Digit a a
MSI-Plessey, MOD 10 Check Digit * a a
Paraf Support a a
ITF Symbol Lengths Variable a a
Minimum Symbol Length 4 a a
Symbol Length Lock None a a
Bars High as Code 39 * a
Spaces High as Code 39 a
Bars High as Scanned a
Spaces High as Scanned a
DTS/SIEMENS