Metrologic Instruments IS6520 - Manual (Page 16)

9
M OUNTING H OLES
Each IS6520/MS6520 Cubit™ is equipped with three threaded mounting holes
located on the back of the scanner. The following diagram shows the exact
location of each mounting hole. The mounting holes are 6 millimeters deep and
are threaded for use with 3 millimeter screws.
Caution: Using a screw that is longer than 6 millimeters can
potentially damage the scanner.
62 mm (2.4")
41 mm (1.6")
20 mm (0.8")
0 mm (0")
0 mm
(0")
20 mm
(0.8")
82 mm
(3.2")