MartinLogan 1000 - Manual (Page 6)

6 Installation in Brief
I
nStallatIon In
B
rIef
We know that you are eager to hear your new Dynamo
1000 subwoofer, so this section is provided to allow fast and
easy set up. Once you have it operational, please take the
time to read, in depth, the rest of the information in this manual.
It will give you perspective on how to attain the greatest pos-
sible performance from this most exacting subwoofer system.
If you experience any difficulties in setup or operation of
the Dynamo 1000, please refer to the Placement, Room
Acoustics and Connections and Control Settings sections.
Should you encounter a persistent problem that cannot
be resolved, please contact your authorized MartinLogan
dealer. They will provide you with the appropriate techni-
cal analysis to alleviate the situation.
Step 1: Unpacking
Remove your new subwoofer from its packing.
Step 2: Placement
Ideally, place the Dynamo 1000 in a corner near the front
of the room. This is a good place to start. Please see the
Placement section (page 11) of this manual for more details.
Step 3: Signal Connection
Use the best cables you can. High quality cables, available
from your specialty dealer, are recommended and will
give you superior performance.
Attach your preamplifier/processor outputs through cables
to the signal input area located on the Dynamo 1000’s
rear panel. Please see the Connections and Control
Settings section (pages 8–10) of this manual for more
details.
Step 4: Power Connection (AC) (see warning)
Make sure the level knob is set at 'Min'. Plug the Dynamo
1000 subwoofer into a wall outlet. Review the AC Power
Connection section (page 10) of this manual for more
details.
Step 5: Setting the Controls
Set the level knob to a medium volume position (12
o'clock). Set the power switch to ‘Auto On'.
Step 6: Listen and Enjoy
Now, you may adjust your system and enjoy!