Miller Electric OM-1589 - Manual (Page 33)

OM-1589 Page 27
.
See Menu Guide for detailed
programming steps.
The security feature allows a mini-
mum and maximum range limit to
be defined for trim, inches per min-
ute (IPM), and ShpArc (see Section
11).
When the security lock is Off, the
full range of values is available for
each parameter.
When the security lock is On, the
range of values available for each
parameter is the defined value plus
or minus the defined range.
For example, if the IPM value is de-
fined as 125, and the range is de-
fined as 50, the actual range of
available IPM is 75 to 175 IPM (125
minus 50, and 125 plus 50).
1 Card Display
2 Moving Line
Moving line is under value that can
be changed. Change program
number to access desired program.
3 Lock On/Off
Toggles security feature On or Off.
Definable values are displayed
when Lock On is selected. Use side
panel controls to change values.
4 Trim And Range Display
5 IPM And Range Display
6 ShpArc And Range Display
Definable Values:
Trim: 0−99 Range: 0−99
IPM: 70−875 Range: 0−875
ShpArc : 0−20 Range: 0−20
Sequence
Dual Schd
Card
> Security
> Prog X
Lock Off
1
2
7-4. Security Feature
.
The data card must be installed for the security feature to be available.
Sequence
Dual Schd
Card
> Security
Prog X
> Lock Off
3
Sequence
Dual Schd
Card
> Security
Prog X
> Lock On
Trim XX
Range XX
3
Sequence
Dual Schd
Card
> Security
Trim XX
Range XX
> IPM XXX
Range XXX
Sequence
Dual Schd
Card
> Security
Prog X
Lock On
> Trim XX
Range XX
4
Sequence
Dual Schd
Card
> Security
IPM XXX
Range XXX
> ShpArc XX
Range XX
5
6