McIntosh MA6300 User Manual

Page 17

How to use the Remote Control

The supplied Remote Control is capable of directly con-

trolling the functions of contemporary McIntosh Source

Components connected to the MA6300. Earlier McIntosh

source components and other brand source components

can be controlled by the MA6300 Remote Control with the

addition of a McIntosh Remote Control Translator (RCT).

Note: Your McIntosh Dealer can assist you with the instal-

lation and operation of the Remote Control Translator

(RCT).

Input Source Selection

Press the appropriate Source Push-button to select the

desired program source.

Mute

Press the MUTE Push-button to mute the audio in all out-

puts except the HEADPHONES and TAPE OUTPUT. The

MUTE LED above the push-button will flash on and off

to indicate that Mute is active. To un-mute the audio, press

MUTE Push-button again.

Mono

Press the MONO Push-button to switch from Stereo to

Mono for Monophonic listening.

Disc, Server and Tape Functions

Use these push-buttons to operate a DVD Player, CD

Player, CD Changer, Music Server or Tape Recorder.

Numbered Push-buttons

Press Push-buttons 0 through 9 to access tuner station pre-

sets, tracks on discs or selections on a Music Server.

Disc and Track

Use the DISC and TRACK Push-buttons when a Disc

Player or Music Server is being used.

Tuner Push-buttons

Press the AM or FM Push-button to select the desired

broadcast band. Press and release the Channel Up or

Down Push-button to move from station to station. Press

and hold a Channel Up or Down Push-button to move

continuously from station to station. Press +10 Push-button

to start the automatic brief audition of each of the pre-

sets stored in the tuner memory. Press +10 Push-button a

second time to stop on a station preset and exit the review

process.

Volume

Press the Up or Down VOLUME Push-button to raise

or lower the listening volume level.

Note: The Record Signals present at TAPE OUTPUTS are not

affected by volume changes.

Pause

Press Pause Pushbutton to perform various functions

on a variety of McIntosh Components. It will also pause

the playing of a disc or tape player. The Pause Push-but-

ton will also allow for quick exiting from the active menu

when in the setup mode. The Pause Push-button is also

used as an Enter Push-button with some McIntosh compo-

nents

Acc On

Press ACC ON to turn the power ON to a McIntosh Disc

Player.

Acc Off

Press ACC OFF to turn the power OFF to a McIntosh Disc

Player..