Memorex MPH6990 - Manual (Page 36)

35
The Answering Machine
(continued)
Setting a Personal Security Code (PIN)
To play your messages from a remote location, you will need to enter a two-digit
Personal Identification Number (PIN) code (00-99). To select a PIN, perform the
following steps:
1
Press MENU twice.
“Security code” and the current PIN code is announced as it is displayed on
the base.
2
Press SKIP or REPEAT until the desired number appears.
3
Press SET/RINGER to select the PIN code. You hear a tone and the system
announces “Security code” and the new PIN code.
Note The PIN code is set to “80” when you purchase the phone.
Setting the ring time
The ring time setting allows you to set the number of rings the caller hears before
your answering system plays the outgoing message. You can set the ring time to
answer after two, four, or six rings. Setting
(Toll Saver), the answering system
picks up after two rings if you have new messages, and after four rings if there are
none. This way, if you make a long distance call to check your messages, you can
hang up after the second ring to avoid billing charges.
1
Press MENU three times.
You hear “Ring time” and the current ring time ([ ] 2, [ ] 4, [ ] 6,
[ ] Toll saver), and it is displayed on the base.
2
Press SKIP or REPEAT until the desired ring time appears.
3
Press SET/RINGER to select the new ring time. You hear a tone and the system
announces “Ring time” and the new ring time.
UC374BH(MPH6990) OM ENG 6/5/02 8:57 AM Page 35