MGE UPS Systems Pulsar EX 2200RT - Manual (Page 17)

3400753300/AE - Page 17
"ON / OFF conditions" tab
Options
Once a day
Once a month
No test
From 0% to 100% of the remaining
battery backup time
Disabled
Default setting
Every weeks
20% remaining
battery backup time
Enabled
Personalization function
Automatic "Battery test" intervals
"Low-battery warning" threshold
Protection against deep discharges
"Battery" tab
Personalization parameters can be set and modified using the UPS Driver software installed on a computer that is
connected to the UPS (see section 2.4 Connection to the RS232 communication port).
NOTE: Check that the RS232 30 cable is properly connected.
UPS Driver installation:
1. Insert the Solution-Pac CD-ROM containing the UPS Driver software into your computers CD ROM drive.
2. Open the file Manager and select the CD-ROM drive.
3. Launch "\Emb
\ Config\UPSDRVxx.exe" (xx = software version).
IMPORTANT: You can download the software UPS Driver from the www.mgeups.com as well, or contact an
MGE representative in your area. Once UPS Driver has been installed, the UPS parameters listed below can be
modified.
3.4 Personalization (optional)
Function
3. Operation
Options
Disabled
Disabled
Disabled
Enabled
Disabled
Default setting
Enabled
Enabled
Enabled
Disabled
Enabled
Personalization function
Automatic start
Cold start (battery power)
Forced shutdown
Sleep mode
UPS ON / OFF via software