Multi-Tech Systems MT9234ZBA User Manual
Multimodem, Mt9234zba-series, User guide
Table of contents
Document Outline
- PN S000387A, Version A
- Copyright
- Revisions
- Trademarks
- Patents
- World Headquarters
- Technical Support
- Country By Email By Phone
- Chapter 1 – Introduction
- Chapter 2 – Installation
- Chapter 3 – Operation
- Chapter 5 – Callback Security
- Chapter 6 – Troubleshooting
- None of the Indicators Light
- The Modem Does Not Respond to Commands
- The Modem Cannot Connect When Dialing
- The Modem Disconnects While Online
- Modem Cannot Connect When Answering
- File Transfer Is Slower Than It Should Be
- Data Is Being Lost
- There Are Garbage Characters on the Monitor
- The Modem Doesn’t Work with Caller ID
- Fax and Data Software Can’t Run at the Same Time
- Chapter 7 – Warranty, Service, and Technical Support
- Appendix A – Upgrading the Modem’s Firmware
- Appendix B – Regulatory Compliance
- Appendix C – Waste Electrical and Electronic Equipment
- Appendix D – Installing a Modem under Linux
- Appendix E – Connecting to a Cisco Router
- Connecting to a Cisco Router Console Port
- Step 1: Configure the Modem for your Country or Region
- Step 2: Configure for Callback Security in Direct Connect Mode
- To Turn Direct Connect Callback Security On and Off
- To Set the Parity of the Callback Security Messages
- To Assign Callback Passwords
- To Call a Modem Configured for Callback Security
- Appendix F – C-ROHS HT/TS Substance Concentration
- Index