Mark Levinson OWNER'S MANUAL N33H - Manual (Page 27)

23
Specifications
The correlation between published specifications and performance
is unreliable. Measurements of your amplifier yield excellent
results by any standards. However, only those specifications that
apply to its actual operation are included here.
All specifications are subject to change at any time.
Rated power output: • 34.6 Vrms (150 W) @ 8
Ω
• 34.6 Vrms (300 W) @ 4
Ω
All of the above power ratings were measured as continuous (rms)
power from 20Hz–20kHz with no more than 0.3% THD.
Frequency response: • Within 0.2 dB from 20Hz to 20kHz
Signal-to-Noise ratio: • –75 dB CCIR
Input impedance: • 100k
Ω
(balanced)
• 50k
Ω
(unbalanced)
Voltage gain: • 26.8 dB
Input sensitivity: • 1.59V (full-rated output)
Power consumption: • 360W in idle; 130W in standby
Mains voltage: • Determined by the requirements of the country for which the
unit was manufactured; cannot be reset by dealer or user
Overall dimensions: • See “Dimensions”
Shipping weight: • 220 pounds (100 kg)
Connector complement: • Four custom binding posts
• One 3-pin XLR balanced input connector
• One RCA input connector
• Two 1⁄8" mini-jacks for remote turn-on
• Two Mark Levinson communications ports on RJ-11
• One captive high-current AC receptacle
Output impedance: • Less than 0.05
Ω
from 20–20,000Hz