Mark Levinson OWNER'S MANUAL N33H - Manual (Page 15)

11 Caution!
Before making any connections, turn the master volume on the
associated preamplifier all the way down, then power off the
Nº33H and all associated components and disconnect them
from electrical outlets.
1. ~ac mains
Provides power to the Nº33H when the power cord is connect-
ed to an electrical outlet. One high-current AC power cord is
provided. This cord is specially designed to support potential
current requirements when the Nº33H is driving low-imped-
ance loads.
Warning!
The Nº33H has been safety-tested and designed for operation
with a three-conductor power cord. Do not defeat the “third
pin” or “earth ground” of the power cord.
Danger!
Dangerous voltages and current capabilities exist within the
Nº33H, even when the power cord is unplugged. There are no
user-serviceable parts inside the amplifier. Refer all servicing to
an authorized Mark Levinson dealer.
Rear Panel
balanced single ended
inputs
MONAURAL POWER AMPLIFIER Nº 33H
c o m m u n i c a t i o n p o r t s
slave out slave in remote turn-on jacks
~ ac mains relay ~ ac mains 875W
4
3
6 7
5 5
2 1
US C
Class 2 wiring
o u t p u t s + -
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
ATTENTION CAUTION
DO NOT OPEN RISK OF ELECTRIC SHOCK NE PAS OUVRIR RISQUE DE CHOC ELECTRIQUE