Metrologic Instruments Voyager MS9500 Series - Manual (Page 37)

33
D
EFAULT
S
ETTINGS
Many functions of the scanner can be configured or enabled/disabled.
The scanner is shipped from the factory configured to a set of default conditions.
All default parameters of the scanner have an asterisk ( * ) marked in the default
column. If an asterisk is not in the default column then the default setting is off or
disabled. Not every interface supports every parameter. A check
mark ( ) will appear in the interface column if it supports the parameter listed.
Parameter Default RS232
Light
Pen
RS485 KBW USB Laser Emulation
Normal Scan Mode *
Continuous Scan Mode
Blinky Scan
Continuous Blinky Scan
Custom (one shot) Scan
Manual Activation Mode
Long-Range In-Stand *
Short-Range In-Stand
Long-Range Out-of-Stand *
Short-Range Out-of-Stand
CodeGate Active In-Stand
CodeGate Inactive In-Stand *
CodeGate Active
Out-of Stand
*
CodeGate Inactive
Out-of Stand
UPC/EAN *
Code 128 *
Code 93 *
Codabar *
Interleaved 2 of 5 (ITF) *
MOD 10 check on ITF
Code 11
Code 39 *
Full ASCII Code 39