Metrologic Instruments Voyager MS9500 Series - Manual (Page 34)

30
RS232 D
EMONSTRATION
P
ROGRAM
If an RS232 scanner is not communicating with an IBM compatible PC, key in the
following BASIC program to test that the communication port and scanner are
working.
This program is for demonstration purposes only. It is only intended to prove that
cabling is correct, the COM port is working, and the scanner is working. If the
bar code data displays on the screen while using this program, the hardware
interface and scanner are working. The next step would be to investigate
whether the application software and the scanner configuration match.
If the application does not support RS232 scanners, a software wedge program
is available that will take RS232 data and place it into a keyboard buffer. This
program tells the PC to ignore RTS-CTS, Data Set Ready (DSR) and Data
Carrier Detect (DCD) signals. If the demonstration program works but the
customer's application software does not, jumper RTS to CTS and Data Terminal
Reading (DTR) to DCD and DSR on the back of your PC.
10 CLS
20
ON ERROR GOTO 100
30 OPEN “COM1:9600,S,7,1,CSO,DSO,CD0,LF” AS#1
35 PRINT “SCAN A FEW BAR CODES”
40 LINE INPUT #1, BARCODE$
50 PRINT BARCODE$
60 K$ = INKEY$: IF K$ = CHR$(27) THEN GOTO 32766
70 GOTO 40
100 PRINT “ERROR NO.”; ERR ;“PRESS ANY KEY TO TERMINATE.”
110 KK$ = INKEY$: IF K$ = “”THEN GOTO 110
32766 CLOSE: SYSTEM
32767 END