beautypg.com

Operating instructions – Majestic Appliances 36LDVR User Manual

Page 22

background image

22

LDVR Series Direct Vent Gas Fireplace

10007317

Only glass approved by CFM Specialty

Home Products should be used on this

fireplace.

The top louvre panel

is removed by lifting

the panel vertically and

pulling it away from the

appliance. (Fig. 39) The

lower access door is

hinged along the bottom

edge and is folded

down to allow access.

1. Turn the fireplace OFF (including the pilot)

2. If the unit has been operating allow time for the

components to cool.

3. Remove the top louvre assembly.

4. Open the lower louvre panel.

5. Release the two clamps securing the lower edge of

the window frame assembly by pulling down on the

handles. (Fig. 40)

6. Tilt the window frame assembly out slightly at the

bottom, lift the window frame assembly up and away

from the fireplace.

7. To replace the window frame assembly reverse

the procedure.

It is necessary to periodically clean glass. During start-

up condensation, which is normal, forms on the inside

of the glass. This condensation causes lint, dust and

other airborne particles to cling to glass surface.
Also initial paint curing may deposit a slight film on

the glass. It is therefore recommended the glass be

cleaned two or three times with a non-ammonia based

household cleaner and warm water (We recommend

gas fireplace glass cleaner) within the first few weeks of

operation.
After the initial cleaning process the glass should be

cleaned two or three times during each operating

season depending on the environment in the house.

The use of any non-approved replacement glass will

void all product warranties.

Care must be taken to avoid breakage of the glass.

Do not operate appliance with glass front

removed, cracked or broken.

Replacement glass (complete with gasket) is

available through your CFM Specialty Home

Products dealer and should only be installed by

a licensed qualified service person.

Clean glass after first two weeks of

operation.
Do not clean glass when hot.
Do not use abrasive cleaners.
Do not strike or slam the glass.

Operating Instructions

Glass Information

Window Frame Assembly Removal

Glass Cleaning

Louvre Removal

1.

2.

FP1227

Louvre removal

11/02

Louvre

Glass Panel

FP1227

Fig. 39 Remove top louvre

assembly.

FP1228

remove glass frame

11/02

Lower Clamps

Window

Frame

Assembly

Push

Clamp

Handle

Pull Clamp

Hook

Window

Frame

Assembly

FP1228

Fig. 40 Window frame assembly removal.

This manual is related to the following products: