MITSUBISHI ELECTRIC LVP-XD10U User Manual
Lvp-xd10u lvp-sd10u
Table of contents
Document Outline
- Data Projector
- LVP-XD10U
- LVP-SD10U
- Copyright
- Disclaimer
- Warning
- COMPLIANCE NOTICE
- Caution
- Safety Instructions
- 1. Read all of these instructions before you operate your projector and save them for future refe...
- 2. The lamp becomes extremely hot during operation. Allow the projector to cool for approximately...
- 3. Power is still available when the projector is in the standby mode. Never replace the lamp ass...
- 4. Do not attempt to service this product yourself, as opening or removing the covers may damage ...
- 5. Do not place this product on an unstable cart, stand, or table. The product may fall, causing ...
- 6. The Standard Remote Control contains a low-power laser that acts as a pointing device during p...
- 7. This product is capable of displaying inverted images for ceiling mount configurations. Please...
- 8. Openings in the front or at the two sides are for ventilation. They must not be blocked or cov...
- 9. For ventilation reasons, the fan continues to operate for about 1 minute after the projector h...
- 10. Do not look straight at the projector lens during operation. The intense light beam may injur...
- Outline
- Table of Contents
- A Image Resolution
- B Brightness
- C Portability
- D Keystone
- E Multilanguage
- F Auto Detect System
- G Ceiling Mount and Rear Screen Projection
- H AV box (Model name: VA-10U)
- A FRONT (figure)
- B REAR (figure)
- C BOTTOM (figure)
- A Positioning
- B Adjustable Feet
- A Connecting the Projector to Computer/Notebook
- A Power on
- B Standby
- A Control Pad
- MAIN UNIT
- FUNCTION
- MAIN UNIT
- FUNCTION
- Main Unit
- Function
- Inserting Batteries in the Remote Control
- A Lamp/temperature Status LED Indicator
- 1. Lamp in excess of service hours
- 1. "PLEASE CHANGE A NEW LAMP. AND RESET THE LAMP TIMER" will be displayed on the screen if the la...
- 2. "PLEASE CHANGE A NEW LAMP. THE POWER WILL TURN OFF AFTER 20 HOURS" will be displayed on the sc...
- 3. "PLEASE CHANGE A NEW LAMP" will blink on the screen together with a green LED if the lamp has ...
- 2. Lamp is not well attached
- 3. Temperature is too high
- 4. Normal status
- 1. Lamp in excess of service hours
- B Replacing the Lamp
- OSD
- FUNCTION
- OSD
- FUNCTION
- Setting effects
- Setting effects
- Setting effects
- OSD
- FUNCTION
- PROBLEMS
- TRY THESE SOLUTIONS