Mercedes-Benz S-Class - Manual (Page 215)

213
Controls in detail
Power tilt/sliding sunroof
Stopping the power tilt/sliding sunroof
during Express-operation
̈ Move the switch in any direction.
Synchronizing the power tilt/sliding
sunroof
The tilt/sliding sunroof must be synchro-
nized
ț after the battery has been
disconnected or discharged
ț after the tilt/sliding sunroof has been
closed manually (
୴ page 386)
ț the tilt/sliding sunroof does not open
smoothly
ț after a malfunction
̈ Switch on ignition ( ୴ page 34).
̈ Press and hold the sunroof switch in di-
rection of arrow 1 until the tilt/sliding
sunroof is fully raised at the rear.
Keep holding the sunroof switch in the
direction of arrow 1 for approximately
one second.
̈ Check the Express-open feature
(
୴ page 212).
If the tilt/sliding sunroof opens com-
pletely, the sunroof is synchronized.
Otherwise repeat the above steps.
i
The selecting a tilt/sliding sunroof
opening position feature is activated
for Canada vehicles, but deactivated
for U.S. vehicles at the factory. If you
wish to have it activated, contact an au-
thorized Mercedes-Benz Center.
To select a tilt/sliding sunroof opening
position, press the sunroof switch to
the resistance point and release it
when the tilt/sliding sunroof has
reached the desired position. The
tilt/sliding sunroof now opens to the
position set when the sunroof switch is
pressed past the resistance point in the
“open” direction.
i
If the movement of the tilt/sliding sun-
roof is blocked during the closing pro-
cedure, the sunroof will stop and
reopen slightly.