Morphy Richards Storm hard floor cylinder vacuum cleaner - Manual (Page 8)

8
Changing/cleaning
the motor
protection filter
The motor protection is accessible from
the dust compartment only when the dust
bag has been removed first.
IMPORTANT: Never use the appliance
without the motor protection filter installed,
otherwise damage to the motor may occur
which would not be covered by the
guarantee.
1 Slide the filter upwards to remove.
2 Open the flap on the filter holder.
3 Take out the filter and clean (by shaking)
or wash.
4 To wash the filter, gently wash in warm
water and leave to air dry. Do not use
detergents. Ensure the filter is fully dry
before replacing into the machine.
5 Close the filter holder and place back into
position before removed.
It is recommended that this filter is
cleaned everytime the dustbag is changed,
and is replaced every 5 dustbag changes.
70312 Rev 2 15/10/04 11:14 AM Page 8