Murray TM6100X5A - Manual (Page 9)

OPERATION
9
F-050204L
HOW TO USE THE
TRIMMER HEAD DRIVE LEVER
1. To engage the trimmer head, hold the con-
trol bail against the handle. Move the
trimmer head drive lever forward to en-
gage the trimmer head. See Figure 5. The
faster the engine runs, the faster the trim-
mer head will rotate.
2. Once the trimmer head is rotating, push
the trimmer forward to trim.
Figure 5
Trimmer Head
Drive Lever
Control Bail
Handle
HOW TO USE THE
THROTTLE CONTROL
1. During normal use, set the throttle con-
trol lever in the FAST position to run the
engine at full speed.
2. Pull the throttle control lever back to de-
crease engine speed. Push the throttle
control lever forward to increase engine
speed.
3. To stop the engine, pull the throttle con-
trol lever completely back to the STOP
position.
Figure 6
Throttle Control
Lever
HOW TO USE
THE PRIMER BUTTON
1. Push the primer button five times. See
Figure 7 for location. Wait approximately
two seconds between each push.
NOTE: Do not use the primer button to re-
start a warm engine after a short shutdown.
Figure 7
Primer
Button