beautypg.com

Installation requirements, Wsm6300 assembly, Figure 1 – Motorola WSM6300 User Manual

Page 8

background image

Installation Requirements

The Mesh Serial Modem will require the following in a typical installation:

• 5 – 14.0 VDC Power.
• A suitable mounting location
• Antenna and RF cabling appropriate for use in the 2.4 GHz band.

WSM6300 Assembly

The external connection points on a WSM6300 unit are shown below.

• The power / serial connector interface is shown on the upper left corner below.
• The antenna port (N-type male) is shown on the upper right corner below.
• The transceiver MAC address is recorded on the label located on front side of the WSM

unit. Record the MAC Address in the table in the WSM6300 MAC Addresses section of
this document.

Figure 1.

WSM6300 Assembly

2

See also other documents in the category Motorola Hardware: