Connecting a dtv receiver, Dtv receiver with component video connections, Recommended) – MITSUBISHI ELECTRIC LT-2240 User Manual

Page 19: Figure 11)

Connecting a DTV Receiver

DTV Receiver with Component

Video Connections

(Recommended)

(Figure 11)

1. Connect the outside antenna cable, or satellite to

ANT or SATELLITE IN on the DTV receiver

(see your DTV receiver owner’s guide for
instructions and cable compatibility).

2. If your DTV receiver has a built-in terrestrial tuner,

connect the incoming terrestrial antenna to ANT
on the DTV receiver. If your DTV receiver does
not have a built-in terrestrial tuner, this TV will
only be able to provide an analog signal through

ANT on the TV side panel.

3. Connect the RCA-type cables from the DTV

receiver outputs to the TV side panel. Component

(1 or 2) may be used for 480i, 480p, 720p or 1080i

components.

4. Connect the L (left) and R (right) audio cables

from the DTV receiver to AUDIO INPUT-1 or

INPUT-2 on the TV back panel.

5. To utilize the benefits of a digital A/V receiver,

connect your DTV receiver’s digital audio out to a
digital input on your digital A/V receiver.

See Appendix B, page 58 for component video

signal compatibility information.

For digital audio connections, see your DTV

receiver and A/V receiver Owner’s Guides.

Figure 11. Connecting a DTV receiver with
component Video Connections.

Note: The TV side panel and connections shown here are for reference only and may vary by model.

��

�

� ��

�

��

��
��

��

�

��

�

��

�

��

�

� ��

�

This manual is related to the following products:

LT-3040