MITSUBISHI ELECTRIC EXTRON 4XIXIXIXIXI - Manual (Page 6)

Extron • System 4 xi xi xi xi xi Switcher Series • User’s Manual • P/N 68-401-02 Rev. C
Mitsubishi Installation Configuration and Connections
Page 6
Connecting System 4 xi xi xi xi xi to Mitsubishi LVP-X200 Projector
If the System 4 xi is already configured for a Mitsubishi LVP-X200 projector, go
to step 4. If it is not set up correctly, it will be necessary to change switch
settings on the System 4
xi ’s Main Controller Board. Begin at Step 1 to verify the
correct configuration.
1. Use the Front Panel to display the Information Menu to verify that the System 4 xi
is already set up for the Mitsubishi LVP-X200 projector. Apply power to the
System 4
xi and do the following:
a. Press to display the M
ENU
S
ELECT
on the LCD screen.
b. Press or to step to Menu 8.
c. Press to select this menu.
d. Press or to display the configuration. The example to the left is general,
yours will show the System 4 xi model name, the software version and the
following information:
PRJ = MITS
PRJ BAUD = 9600
UNIT No. = 000
HST BAUD = 9600 (value depends upon setup Menu 3)
2. Go to the procedure on page 2-3 of the System 4 xi User’s Manual to remove the
System 4 xi cover. Then go to page 2-4 and refer to the configuration below to
set up the Main Controller board. Continue with Step 3 (below) when the
configuration is correct.
Config Projector SW1: 1-2-3-4 SW2 SW3 SW4 SW5 SW6 Prj Cable Comm
as Adapter
Mits. LVP-X200 off-on-off-on 0 1 6 F 0 J15 26-475-01
3. Double-check your work and be sure the System 4 xi cover is on securely.
4. Install the System 4 xi in its place of operation (i.e. rack), but not powered on.
__________ Changes in some switch configurations are not detected until the power is
removed at the AC cord, and then restored.
Refer to the following cable diagram and continue.
5. The Mitsubishi LVP-X200 Comm Adapter (26-475-01) has two 9-pin male
connectors. Plug the Comm Extension cable into the Comm Adapter. Plug the
other end of the Comm Adapter into the “RS-232C” connector of the projector.
}
SW1
ON
SW2
SW4
SW3 SW5
J15
3 4 1 2
(Note: Information depends on
System 4
NE setup.)
(See note.)
(See note.)
(See note.)
(See note.)
[System 4 NE model and software
version displayed here]