Multi-Tech Systems MVP110 - Manual (Page 16)

MultiVOIP Quick Start Guide
16
again. This option is available for all interface types. In
the Flash Timer box, enter the time, in milliseconds, for
the duration of flash hook signals output on the interface.
To dedicate the local voice/fax channel to a remote voice/
fax channel, (so you will not have to dial the remote
channel) select the Auto Call Enable check box. Enter
the phone number of the remote VOIP in the Phone
Number box.
The Voice/Fax tab displays the parameters for the voice
coder, faxing, and DTMF gain.
15. To change the voice coder, select the new voice coder
entry from the Voice Coder list.
If you changed the voice coder, ensure that the same
voice coder is used on the voice/fax channel you are
calling. Otherwise, you will get a busy signal.
16. The Fax group enables you to select the maximum baud
rate for faxes and adjust the fax volume. If you do not plan
to send or receive faxes on a given voice/fax channel, you
can disable faxes in the Fax group.