MTD 611 - Manual (Page 5)

5
SECTION 2: CONTENTS OF HARDWARE PACK (Boxed Unit)
Lay out the hardware according to the illustration below for identification purposes. Part numbers are shown in
parentheses. (Hardware pack may contain extra items which are not used on your unit.)
NOTE: These are replacement shear bolts and nuts. Store in a safe place until needed.
A B
C
E
F
H
G
D
ATTACHING THE HANDLES
Hex Bolts
710-04039 (2)
Hex Bolts
710-1880 (2)
ATTACHING CLUTCH GRIPS
Lock Washers
736-0119 (4)
Saddle
784-5599 (2)
ATTACHING HANDLE PANEL
Carriage Bolts
710-0262 (4)
Hex Patch Nuts
712-3068 (4)
Lock Washers
736-0119 (4)
ATTACHING SPEED SELECTOR PLATE
Self-Tapping Screws
710-0599 (4)
Hex Bolts
710-3015 (2)
Hex Lock Nuts
712-3027 (2)
“Z” FITTING NUTS
Hex Nuts
712-0121 (4)
ATTACHING CHUTE ASSEMBLY
Hex Bolts
710-3015 (6) Hex Lock Nuts
712-3027 (6)
Chute Flange Keepers
731-0851 (3) Not Shown
ATTACHING CHUTE DIRECTIONAL CONTROL
Hex Lock Nuts
712-0429 (2)
REPLACEMENT SHEAR BOLTS
Hex Bolts
710-0890A (2)
Hex Lock Nut
712-0429 (2) Spacer
750-1032 (2) Hex Cap Screw
710-3103 (2)
(No Picture) (No Picture)
Flat Washer
736-0185
Cupped Washer
736-0242
Hex Nuts
712-3010 (2)
Hairpin Clip
714-0104
AND SHIFT LEVER
“Z” Fitting not
shown here
See note
below.