J. preoperational instructions c – Maytag MDG-30 User Manual

Page 33

5. Make a complete operational check of ALL operating controls.

NOTE: If computer program changes are required, refer to the computer programming section of the

manual supplied with the dryer.

6. The dryer should be operated through one (1) complete cycle to assure that no further adjustments are

necessary and that ALL components are functioning properly.

IMPORTANT: The dryer basket (tumbler) is treated with a protective coating. ADC suggests

tumbling old clothes or material in the basket (tumbler), using a mild detergent to

remove the protective coating.

7. Check the electric service phase sequence (3-phase [3ø] models only). While the dryer is operating, check to

see if the blower wheel (impeller/fan) is rotating in the proper direction. Looking from the front, the blower

(impellor/fan) wheel should spin in the clockwise (CW) direction. If it is, the phasing is correct. If the phasing

is incorrect, reverse two (2) of the three (3) leads at connections L1, L2, L3 of the power supply to the dryer.

IMPORTANT: If the blower wheel (impellor and fan) is rotating in the wrong direction, this will not only

drastically reduce drying efficiency, but it can also cause premature component failure.

J. PREOPERATIONAL INSTRUCTIONS

OIN

ODELS

1.Automatic Mode (Microprocessor [Computer] Models)

a. When turning on power or when no cycle is in progress, the L.E.D. (light emitting diode) display will read

"FILL" or "Amount to Start."

b. Insert coins.

Once correct "Amount to Start" has been inserted the L.E.D. (light emitting diode) display will read

"PUSH."

c. Select temperature by pushing "HI TEMP," "LO TEMP," or "PERM PRESS." The dryer will start, the

L.E.D. (light emitting diode) display will read the temperature cycle selected, and the drying time portion

of the L.E.D. (light emitting diode) display will read "00" and count upward as time elapses.

IMPORTANT: If the door is opened during a cycle, both the heat and motor will stop. However, the

microprocessor controller (computer) will continue to count downward in time.

Continuation of the cycle will resume only after the door has been closed and any

other of the three (3) temperature selection buttons is again depressed.

d. Once the preprogrammed dryness level and cool down period have been reached, or the maximum

automatic time has expired, the tone (buzzer) will sound for five (5) seconds, and the L.E.D. (light emitting

diode) display will read "donE," at which time the dryer will shut off.