Multi-Tech Systems Modem Module MT3334SMI - Manual (Page 43)

Chapter 4 - Class 2 Fax Commands
MT3334SMI 43
50 - 69 Transmit phase D hang-up codes
52: No response to MPS repeated 3 times
53: Invalid response to MPS
54: No response to EOP repeated 3 times
55: Invalid response to EOP
56: No response to EOM repeated 3 times
57: Invalid response to EOM
70 - 89 Receive phase B hang-up codes
90 - 99 Receive phase C hang-up codes
90: Unspecified receive phase C error
100 - 119 Receive phase D hang-up codes
100: Unspecified receive phase D error
120 - 255 Reserved codes
+FBOR Data Bit Order Selection
Command syntax: +FBOR=
0: Direct bit order for both Phase C data and for Phase B/D data
1: Reversed bit order for Phase C data and direct bit order for Phase B/D
data
2: Direct bit order for Phase C data and reversed bit order for Phase B/D
data
3: Reversed bit order for both Phase C data and for Phase B/D data
Note: Direct bit order: First bit transferred of each byte on the DTE-DCE link is the first bit
transferred in the PSTN data carrier.
Reversed bit order: Last bit transferred of each byte on the DTE-DCE link is the first bit
transferred on the PSTN data carrier.
+FCQ Copy Quality Checking
Command syntax: +FCQ=
0: Disables copy quality checking. The modem will generate Copy Quality
OK (MCF) responses to complete pages and set +FPTS=1.
+FCR Capability to Receive
Command syntax: +FCR=
0: Indicates the modem will not receive message data.
1: Indicates the modem can receive message data.
+FCTCRTY ECM Retry Count
Command syntax: +FCTCRTY=
0: Disable error correcting mode retries. Error correcting mode is not
supported.