beautypg.com

Controls power, Automatic cable rewind, Dustbag replacing the dustbag – Morphy Richards Vacuum Cleaner User Manual

Page 5: Dustbag condition indicator

background image

55

w

ww

ww

w..m

mo

orrp

ph

hyyrriic

ch

ha

arrd

dss..c

co

om

m

CONTROLS

Power

To switch the cleaner on press
the on/off variable power switch

‰ inwards. To switch off press
the on/off switch again.

The suction power can be
adjusted using this switch again.
Turn the switch to the desired
level D.

Suction may also be varied with
the fingertip control on the
handle.

Closed:

full suction

Open: reduced suction

Automatic cable
rewind

After use, unplug and press the
cable rewind button  to retract
the cable.

WARNING: When using the
cable rewind, always hold
the plug as the cable will
rewind quickly.

DUSTBAG

Replacing the
dustbag

To obtain the best results from
your cleaner be sure to check
and change the dustbag
regularly, otherwise the airflow
and cleaning power of your
cleaner will be reduced and you
may damage your cleaner.

Dustbag condition
indicator

If the suction power decreases
of if the dustabg condition
indicator shows fully red then
the bag must be emptied
immediately and/or the motor
protection filter cleaned, even if
the bag does not appear full.
This will also occur if the nozzle,
tubes or hose have become
blocked.

The dustbag indicator may
occasionally show red during
use - this is quite normal.

1

Lift the dust compartment lid

‚.

2

Pull the dustbag retaining clip
forward to release. Carefully lift
the dustbag clear of the cleaner
and dispose of the dustbag.

3

To fit the new dustbag first
locate the bottom end of the
dustbag collar into the guide
slot at the bottom of the
dustbag compartment then pull
the collar forward until it locates
into the securing clip E.

4

The arrow on the collar of the
dustbag must point downwards
when fitting F.

NOTE: The dustbag
compartment lid will close
unless the dustbag is fitted
correctly

IMPORTANT:

All filters should be checked
regularly for signs of damage,
preferably after each cleaning
task.The filters must be replaced
immediately if they become
damaged.

Always disconnect the cleaner
from the mains when checking
filters or replacing dustbag.

Always make sure the dustbag,
grill and filters are fitted before
use. Failure to do so may result
in damage to your product.

E

D

F

73168 rev1 12/4/07 09:15 Page 5