McIntosh C220 - Manual (Page 15)

15
How to use the Remote Control
How to use the Remote Control
The supplied Remote Control is capable of directly con-
trolling the functions of contemporary McIntosh Source
Components connected to the C220 Tube Preamplifier.
Earlier McIntosh source components and other brand
source components can be controlled by the C220 Remote
Control with the addition of a McIntosh Remote Control
Translator (RCT).
Note: Your McIntosh Dealer can assist you with the instal-
lation and operation of the Remote Control Translator
(RCT).
Input Source Selection
Press the appropriate Source Push-button to select the
desired program source.
Mute
Press the MUTE Push-button to mute audio. The Record
Signals present at the TAPE OUTPUT Jack are not affect-
ed by the MUTE function. The C220 Front Panel Alphanu-
meric Display will indicate the word MUTE. Press MUTE
a second time to unmute audio.
Mode
Press the MODE Push-button to switch from Stereo to
Mono for Monophonic listening.
Disc, Server and Tape Functions
Use these push-buttons to operate a DVD Player, CD
Player, CD Changer, Music Server or Tape Recorder.
Numbered Push-buttons
Press Push-buttons 0 through 9 to access tuner station pre-
sets, tracks on discs or selections on a Music Server.
Disc and Track
Use the DISC and TRACK Push-buttons when a Disc
Player or Music Server is being used.
Tuner Push-buttons
Press the AM or FM Push-button to select the desired
broadcast band. Press and release the CHANnel Up or
Down Push-button to move from station to station. Press
and hold a CHANnel Up or Down Push-button to
move continuously from station to station. Press the +10
Push-button to start the automatic brief audition of each of
the presets stored in the tuner memory. Press +10 Push-
button a second time to stop on a station preset.
Volume
Press the Up or Down VOLUME Push-button to raise
or lower the listening volume level.
Note: The Record Signals present at TAPE OUTPUTS are not
affected by volume changes.
Pause
Press Pause Pushbutton to perform various functions
on a variety of McIntosh Components. It will also pause
the playing of a disc or tape player. The Pause Push-but-
ton will also allow for quick exiting from the active menu
when in the setup mode. The Pause Push-button is also
used as an Enter Push-button with some McIntosh compo-
nents.
Trim
Press the TRIM Push-button until the word “BALANCE”
appears on the Alphanumeric display, then press the
LEVEL Up Push-button to emphasize the Left Channel
or Down Push-button to emphasize the Right Channel.
Press the TRIM Push-button until the word “TRIM _
_ _ _ _” appears on the Alphanumeric display, then press
the LEVEL Up or Down Push-button to match the
volume level of the previously selected Input.
Notes: 1. Refer to “Balance Control (Trim Function)” on
page 16 for additional information.
2. Refer to “Trim Level Adjustment” on page 11 for
additional information.
Acc On
Press ACC ON to turn the power ON to a McIntosh Disc
Player.
Acc Off
Press ACC OFF to turn the power OFF to a McIntosh Disc
Player.
Amplifier Selection
Press the 2nd Push-button followed by the OUTPUT 1
or 2 Push-buttons either separately or together, to control
the rear panel OUTPUTS 1, 2 which can feed signals to a
Power Amplifier or other accessory component.