GE PB3-POS-RP - Manual (Page 23)

23
SW2 - Switches 5-8
Switches 5-8 on SW2 are used to modify the communication
transfer protocol on Port 2 of the PB3 should the POS device
you are using require it. The protocol listed here consists of 3
user definable settings: The Start Bit, The Stop Bit, and Parity.
These can be expressed as follows:
• Stop Bit: 7 or 8-bit ASCII
• Stop Bit: 1 or 2-Stop bits
• Parity: Odd, Even, or None
In the following table 8,1,E would translate to 8-start bits, 1-stop
bit, and Even parity.
SW2
Protocol 5 6 7 8
7,1,N U U U U
7,1,O U U U D
7,1,E U U D U
8,1,N U U D D
8,1,O U D U U
8,1,E U D U D
7,2,N U D D U
7,2,O U D D D
7,2,E D U U U
8,2,N D U U D
8,2,O D U D U
8,2,E D U D D