Grizzly 4" - Manual (Page 11)

t10493, t10494 & t10495 (Mfg since 10/11) -9 -
once assembly is complete and a grinding
wheel is installed (see
installing/changing
grinding Wheel on page 16 for detailed
instructions), test run the grinder to make
sure it runs properly and is ready for regular
operation.
the test run consists of verifying the
following:
• the motor powers up and runs
correctly.
• the safety mechanism works correctly.
note: The Model T10493 has a locking
slide switch. Models T10494 and T10495
have a trigger safety button that must be
depressed before the trigger operates.
if, during the test run, you cannot easily
locate the source of an unusual noise or
vibration, stop using the tool immediately,
then review
troubleshooting on page 14.
if you still cannot remedy a problem, con-
tact our tech support at (570) 546-9663
for assistance
.
to test run the grinder:
1. disConneCt tool FroM poWer!
2. rotate the wheel by hand and make
sure it turns freely and is tightly secure
on the spindle.
3. Confirm that the guard and handle are
in a safe configuration and securely in
place.
test run 4. Make sure you have read and
understand the safety instructions at
the beginning of the manual and that
the grinder is setup properly.
5. Connect the grinder to power, as shown
on page 8. For Model t10493 proceed
to step 6; for Models t10494 and
t10495 skip to step 7.
6. While firmly holding the grinder, turn
the grinder ON. the switch should lock
in the on position.
— if operating correctly, the grinder
will remain running. depressing the
switch will make it spring back and
turn the tool
OFF. the grinder is
ready to use.
— if the locking slide switch does not
automatically return to the oFF
position when pressed, it is not
functioning properly. turn the tool
OFF and contact tech support.
7. press the safety button then pull the
trigger.
— if operating correctly, the tool will
turn on and remain running as
long as you hold down the trigger.
proceed to
step 8.
— if the tool does not turn on the
trigger is not working properly.
disconnect power and contact tech
support.
8. try to depress the trigger without
pressing the trigger safety button.
—if operating correctly, the tool should
not turn on. the grinder is ready
to use.
— if the grinder does turn on the
trigger safety is not working properly.
turn the tool
OFF and contact tech
support.