Grandstream Networks GXV3601 - Manual (Page 22)

GXV3601 IP Camera
Firmware 1.0.4.6 Page 22 of 36
Grandstream Networks, Inc. 09/2010
STUN Server – If the device is behind a router, a STUN server is needed to help
penetrate the NAT.
Stream
– To choose between Primary and Secondary stream.
Preferred Vocoder – To choose different Vocoder type.
Registration Expiration – This parameter allows users to specify the time frequency (in
minutes) in which the GXV refreshes its registration with the specified registrar. The
default interval is 60 minutes.
Local SIP Port
– This parameter defines the local SIP port used to listen and transmit.
The default value is 5060.
Local RTP Port
– This parameter defines the local RTP-RTCP port pair that is used to
listen and transmit. The default value is 5004.
5. Click Save to save all the changes. You need to restart the device to apply all changes.
SIP Open Door Settings
Enable SIP open door – This will close the DO
connections in the back to close the circuit
connected to it.
Key to open the door – DTMF key to close the circuit. Digits 0-9 only.
Delay lock time (seconds)
– This is the time in seconds that the circuit will remain closed
when this function is triggered
Configure Phone List Page
To make sure the GXV3601 can make phone calls to the number you preferred when alarm is
triggered. You need to add number to the phone list.
Steps to add phone number:
1. From the GXV3601 home page, click Basic Settings > SIP.
2. Go to Phone List Tab.
3. Enter the Phone number and name, click Add a Number to save all the changes.
4. Numbers added to the system will be listed in this page.
Available phone numbers