Great Dane Surfer GSRKW2352S - Manual (Page 19)

Service Engine - 17
SERVICE ENGINE
c
1. Clean area around dipstick cap and filter.
2. Start engine and run until it reaches normal operating temperature.
3. Park machine safely. (See Parking Safely in the SAFETY section.)
c
4. Insert drain tube over oil drain fitting (A)
5. Put oil drain pan under drain tube.
6. Loosen drain plug.
7. Allow oil to drain into an oil drain pan.
8. After oil drains, install and securely tighten drain plug.
9. Turn oil filter (B) counterclockwise to remove.
10. Apply a film of clean engine oil to gasket of new filter.
c
11. Install filter. Turn filter clockwise until gasket makes contact with
mounting surface. Tighten 1/2 to 3/4 turn after gasket contact.
12. Raise thigh pad.
13. Remove dipstick cap.
NOTE: Refer to engine manufacturers operating manual for correct
type and grade of oil.
13. Add approximately 1.7 L (1.75 qt.) of oil.
14. Insert dipstick. Tighten cap.
15. Start engine and run at slow throttle for approximately two minutes.
Check for leaks around filter and drain valve.
16. Stop engine.
17. Check oil level:
• Remove dipstick cap. Wipe dipstick clean.
NOTE: Allow dipstick cap to rest on threads of filler tube when
checking oil level. Do not tighten dipstick cap when checking oil
level.
• Insert dipstick and allow cap to rest on threads of filler. Do not tighten
cap.
c
• Remove dipstick. Add oil as needed to bring level to the full mark
without overfilling.
18. Insert dipstick. Tighten cap.
Cleaning Engine Air Intake Screen and Fan
c
c
Keep air intake screens and engine cooling fins clear of debris to ensure
proper cooling. See the engine manufacturer’s owner’s manual provided
with your machine for the complete procedure.
Checking and Cleaning Air Filter Elements
c
NOTE: It may be necessary to check the air filter more frequently if
operating machine in dusty conditions.
Check and clean air filter elements at the intervals recommended in the
Service Intervals section. See the engine manufacturer’s owner’s manual
provided with your machine for the complete procedure.
CAUTION: Avoid injury! Touching hot surfaces can burn
skin. The engine, components, and fluids will be hot if the
engine has been running. Be cautious and wear protective
clothing when servicing or working near a hot engine and
components.
IMPORTANT: Avoid Damage! Change the oil more often if the
machine is used in extreme conditions:
Extremely dusty conditions.
Frequent slow or low-speed operation.
Frequent short trips.
IMPORTANT: Avoid Damage! Do not use wrench to tighten oil
filter.
IMPORTANT: Avoid Damage! To prevent extensive engine wear or
damage, always maintain the proper engine oil level. Never
operate the engine with the oil level below the add mark or over
the full mark.
CAUTION: Avoid injury! Compressed air can cause debris to
fly a long distance.
Clear work area of bystanders.
Wear eye protection when using compressed air for
cleaning purposes.
Reduce compressed air pressure to 210 kPa (30 psi).
IMPORTANT: Avoid damage! An obstructed air intake screen can
cause engine damage due to overheating. Keep air intake screen
and other external surfaces of the engine, including cooling fins,
clean at all times to allow adequate air intake.
CAUTION: Avoid injury! Touching hot surfaces can burn
skin. The engine, components, and fluids will be hot if the
engine has been running. Allow the engine to cool before
servicing or working near the engine and components.
IMPORTANT: Avoid damage! Dirt and debris can enter the engine
through a damaged filter element:
• Do not wash paper element.
• Do not attempt to clean paper element by tapping against
another object.
• Do not use pressurized air to clean element.
• Replace element only if it is very dirty, damaged or the seal is
cracked.