GE Monogram ZET737 - Manual (Page 35)

35
How to Set Delay Start of Cleaning
Delay Start is setting the oven to start the clean
cycle automatically at a later time than the present
time of day.
NOTE: Before beginning, make sure the oven clock
shows the correct time of day.
1. Follow the steps in the Before a Clean
Cycle section.
2. Press SELF CLEAN.
3. Press the number pads to set the
clean time.
4. Press DELAY START.
5. Press the number pads to set the time of
day you want the clean cycle to start.
6. Press START.
The door locks automatically. The
display will show the start time. It will
not be possible to open the oven door
until the temperature drops below the
lock temperature and the LOCKED
DOOR light goes off.
7. When the LOCKED DOOR light is off,
open the door.
START
D E L A Y
S T A R T
S E L F
C L E A N
Easy Steps:
1. Press SELF CLEAN.
2. Press the number pads to set the clean time.
3. Press DELAY START.
4. Press the number pads to set the start time.
5. Press START.
After Self-Cleaning
You may notice some white ash in the oven. Just wipe
it up with a damp cloth after the oven cools.
If white spots remain, remove them with a soap-filled
steel wool pad. Be sure to rinse thoroughly with a
vinegar and water mixture. These deposits are usually
a salt residue that cannot be removed by the clean cycle.
If the oven is not clean after one clean cycle,
repeat the cycle.
NOTE:
• No functions can be programmed before the door
automatically unlocks.
• If the shelves have become hard to slide, wipe the
shelf supports with cooking oil.
(continued next page)