Gefen EXT-HDMI1.3-CAT6-4X - Manual (Page 16)

12
How to Operate the 4x CAT6 Extender for HDMI
(using an 4x4 Matrix)
The front panel of each Receiver unit for the 4x CAT6 Extender for HDMI
contains a set of LED indicators which corresponds to an input (source) on the
4x4 Matrix device. A blue LED indicates which input has been routed from the
4x4 Matrix. On the top of each Receiver unit there are a set of 4 push-buttons
which are used to control the switching of the 4x4 Matrix.
Example 1: Routing Input (source) 3 to Output (display) 4.
1. Connect an HDMI cable from HDMI Out 4 on the 4x4 Matrix to HDMI In 4 on
the 4x CAT6 Extender for HDMI Sender unit.
2. Connect an 4x CAT6 Extender Receiver unit to Display 4.
3. Press button 3 on the top of the Receiver unit. Button 3 is shown below.
The In 3 LED will turn bright blue, indicating that Input 3 on the 4x4 Matrix
has been routed to Display 4 (Zone 4).
Example
: HDMI input 3 is routed to HDMI Out 4 (a picture of the 4x4 Matrix
display panel is shown below). The image shown on Display 4 will be the
HDMI source (3) connected to the 4x4 Matrix.
In 3
Button 3
HDMI cable
To Display 4 CAT-6 from
Out 4 on
Extender
CONNECTING AND OPERATING THE
4X CAT6 EXTENDER FOR HDMI
Input 3 p