Grizzly H7760 - Manual (Page 13)

H7760 2" x 27" Belt Sander & 6" Grinder
-11-
Mounting
The Model H7760 weighs 22 lbs. Make sure
the workbench on which you plan to mount the
grinder is sturdy enough to hold the weight of the
machine and any downward pressure that may be
applied during operation. The workbench should
have a level surface and be heavy, or attached to
the floor so that it will not move during operation.
Components and Hardware Required Qty
Sander/Grinder Unit .......................................... 1
Hex Bolt M8-1.25 (length varies) ....................... 2
Flat Washer 8mm .............................................. 4
Lock Washer 8mm ............................................ 2
Hex Nut M8-1.25 ............................................... 2
The Model H7760 can cause
personal injury if operated
by untrained users. Ensure
that your machine is inac-
cessible to children and visi-
tors by closing and locking
all entrances to your shop/
garage when you are away.
To mount the grinder:
1. Find the best place in your shop to mount the
grinder/sander.
—Pick a spot on the workbench that
will allow enough room to move the
size of an anticipated workpiece around
the grinder. The operator (and possibly
bystanders) should have enough room to
stand out of the way.
—Mount the grinder in an area with
proper lighting and near electrical out-
lets. Lighting should be bright enough to
eliminate shadow and prevent eye strain.
Electrical circuits should be dedicated
or large enough to handle amperage
requirements.
Note: Keep power or extension cords clear
of high-traffic areas. If you install new light-
ing, outlets, or circuits, observe all electrical
codes.
2. Mount the grinder to the workbench with bolts
that are long enough to exceed the thickness
of your workbench and the grinder base.
Secure each bolt with flat washers, a lock
washer, and a hex nut as illustrated in
Figure
5.
Note: Because sizes vary for each individual
situation, the hardware in this step is not included
with the Model H7760.
Figure 5. Mounting machine to the workbench.
H7760
Base
Workbench
Flat
Washer
Flat
Washer
Lock
Washer
Bolt
Nut
NOTICE
When mounted, the cooling tray can be eas-
ily damaged if the grinder is tipped forward.
The following items are needed to complete the
set up process, but are not included with your
machine:
Description Qty
Wrench 8mm ..................................................... 1
Wrench 13mm ................................................... 1
Hex Bolt M8-1.25 (length varies) ....................... 2
Flat Washer 8mm .............................................. 4
Lock Washer 8mm ............................................ 2
Hex Nut M8-1.25 ............................................... 2
Items Needed for
Set Up