GE JKP17 - Manual (Page 7)

Jock To Set the Clock
The must be set for the
automatic oven timing functions to
work properly. The time
day
be changed during a Timed
Bake CLEAN cycle.
❑
1. Press the
CLOCK pad.
CLOCK
2. Press the
A
INCREASE or
DECREASE pad
to set the time
of day.
3. Press the CLOCK pad to start.
Timer To Set the Timer
The timer is a minute timer; it does
not control oven operations. The
maximum setting on the timer is
hours and minutes.
1. Press the TIMER
TIMER
ON/OFF pad.
2. Press the INCREASE or
DECREASE pad to set the
amount
time on timer.
The timer will start automatically
within a few seconds
releasing
the INCREASE or DECREASE pad.
The timer, you are setting it,
will display hours and minutes;
“HR
> ’ will be in the display.
During the countdown, when the
timer reaches the last minute, the
display
change to seconds
only and a single beep will sound.
Reset the Timer To Cancel the Timer
If “TIMER’ - is flashing, press the INCREASE or Press the TIMER ON/OFF pad while the word
DECREASE pad until the desired time is reached. “TIMER” is flashing.
“TIMER” is not flashing, press the TIMER
ON/OFF pad first, then follow the instructions above
to set the timer.
End of Tone
The end of tone is a series of beeps followed
by beep every seconds. If you would like to
remove the
that beeps every 6 seconds, press
and hold the CLEAR/OFF pad for 10 seconds.
To return the signal that beeps every 6 seconds, press
and hold the CLEAR/OFF pad for () seconds.
Power Outage
After a power outage, when power is restored, the
display will and time shown will no longer be
correct—for example, after 5-minute power
interruption the clock will be 5 minutes slow.
other functions that were in operation when the
power went out have to be programmed
7