Grizzly G9958 - Manual (Page 14)

-12- G9958 4 H.P. Dust Collector
Connect the two upper bag supports and hanger
rods using (4)
1 ⁄
4
" x 1 ⁄
2
" hex head bolts. Next, slide
the support bracket assemblies into each of the
mounting holes on the fan/motor assembly and
fasten with (2)
1 ⁄
4
" x 1 ⁄
2
" hex head bolts. See
Figure 9.
Hook the loops at the top of the upper bags over
the support bracket hangers as shown in
Figure
10 . Pull the upper bag openings over the top
opening of the collectors. Cinch the straps and
tighten the bag clamps, securing the upper bags
around the rim of the collector as shown in
Figure
11.
Support Brackets
Figure 9. Attaching the support brackets.
Figure 11. Attaching dust bags.
Figure 10. Hang bags on support hooks.
The dust collector can operate with up to four
machines running simultaneously. Included is a 4
to 1 inlet adapter that allows up to four separate
lines to connect to the main assembly. There are
also two inlet caps to seal off the inlets that are
not used. The inlets and inlet caps are secured to
the main assembly by a press on fit.
4 To 1 Inlet