Grizzly G9958 - Manual (Page 12)

-10- G9958 4 H.P. Dust Collector
SECTION 4: ASSEMBLY
Beginning Assembly
Most of your Model G9958 has been assembled
at the factory, but some parts must be assembled
or installed after delivery. We have organized the
assembly process into steps. Please follow along
in the order presented here.
TOOLS REQUIRED: You will need a 12 and
14mm wrench.
Base
Disconnect power to the
machine when perform-
ing any maintenance,
assembly or adjust-
ments. Failure to do this
may result in serious
personal injury. !
Keep loose clothing
rolled up and out of the
way of machinery and
keep hair pulled back.
Wear safety glasses dur-
ing the entire assembly
process. Failure to com-
ply may result in serious
personal injury.
Start by turning the main base upside down and
placing it on a level surface. Mount four of the
casters to the corners with (16)
5 ⁄
16
" x 1 ⁄
2
" hex bolts
as shown in Figure 3.
Place the left and right side bases upside down
and attach the remaining four casters to the cor-
ners with the four mounting holes as shown in
Figure 4. Use the same fasteners and procedure
as on the main base.
Figure 3. Mounting casters to main base.
Figure 4. Mounting casters to the side bases.
Some metal parts may
have sharp edges on
them after they are
formed. Please examine
the edges of all metal
parts before handling
them. Failure to do so
could result in injury.