GE DECT6.0 28128 - Manual (Page 36)

6
v
olume
s
ettIngs
Speakerphone
Press the SPEAKER button on the base to activate the speakerphone. Use the
VOLUME (5 or 6) buttons to adjust speaker volume on the base to a comfortable
level. VOL1 is the minimum speaker volume and VOL is the maximum.
Handset
When the handset is
oN (in talk mode), you may adjust the receiver volume by
pressing the VOLUME 6 or 5 buttons on the side of the handset. There are four
volume levels to choose from. When the maximum or minimum volume level is
reached, the phone beeps twice. VOL 1 is minimum and VOL 4 is maximum.
m
akIng a
c
all
Landline Calls
1. Press the TALK or SPKR button on handset or SPEAKER button on base. Dial the
desired number.
- or -
Dial the number and then press the TALK or SPKR button on handset or the
SPEAKER button on the base.
- or -
Use the or button to select the desired record, then press the TALK or
SPKR button on handset or the SPEAKER button on the base.
- or -
Press and hold the number key to get the corresponding speed dialing number.
. When finished, press the END/cancel button on the handset or base to hang up.
NoTE: You may enter up to 32 pre-dial digits.
NoTE: If you want to delete the pre-dial number you entered, press
the DELETE/fLASH button until all of the digits are erased.
NoTE: To set the speed dialing number, refer to section “Phone
Book -> Adding the Speed Dialing Number”.
Cellular Calls
1. In standby mode, dial the desired number, press Cell (SKR) button.
NoTE: If more than one bluetooth cell phone device is connected,
use the or button to select the desired device.
. Press Select (SKL) button to confirm.
. Press END/cancel button when finished.