Go-Video DVR 4550 - Manual (Page 47)

41 Appendix A - Advanced Connections
1 C O N N E C T C A B L E T O
C A B L E B O X
Connect an RF coaxial cable from
your cable wall outlet to the Input
jack on the Cable Box.
2 C O N N E C T C A B L E B O X T O
D V D + V C R
Connect a second RF coaxial cable
from the Output jack on the Cable
Box to the “IN (FROM ANT.)” jack
on the back panel of the DVD+VCR.
3 C O N N E C T D V D + V C R T O T V
Connect the supplied RF coaxial
cable from the “OUT (TO TV)” jack
on the back panel of the DVD+VCR
to your television’s “Antenna In”
jack.
4 P L U G I N D V D + V C R
Connect the DVD+VCR power cord
to a standard 120V/60Hz wall outlet.
5 T U R N O N D V D + V C R , T V &
C A B L E B O X
Press POWER on the DVD+VCR, TV,
and Cable Box.
Follow these instructions to connect a Cable
Box to your DVD+VCR.
Input Output
Cable Box
VHF/UHF
TV
From Cable
Wall Outlet
CABLE BOX HOOKUP
6 S E T D V D + V C R O U T P U T
C H A N N E L
Set the CH (channel) switch on the
back panel of the DVD+VCR to 3 or
4, whichever is NOT used by your
cable box.
7 T U N E T V T O T H E S A M E
C H A N N E L
Tune your TV to the same channel
you selected in step 6.
8 C O N N E C T I O N I S C O M P L E T E !
The “Language/Langue/Idioma”
menu will appear on your television
screen. Please proceed with Auto
Setup on page 3.
• Use your cable box to select
channels.
• If you are not getting a good
picture, repeat steps 6 and 7
using the other channel; i.e., try
channel 4 instead of channel 3.