GE Monogram ZFSB26D SS - Manual (Page 6)

Installation Instructions
6
STEP 1A MODEL ZFSB26
MOVE REFRIGERATOR INDOORS
IMPORTANT:
Door and passageways
into the installation location require a 36" min. opening.
If the opening is less than 36", the top cap and doors
must be removed.
NOTE: Skip this step if door removal is not required.
See instructions on next page, “To Move The
Refrigerator Indoors.”
REMOVE THE DOORS
The top cap must be removed to access hinges. It is best
to remove one door at a time.
A. Remove 2 screws and springs on top of the
refrigerator, one on each side. Push the top cap
forward and lift up from the rear.
B. Remove 2 screws holding the top filler strip, lift off.
C. Open both doors. Remove the 2 toekick screws and
pull forward to remove.
D. Disconnect the water line coupler by pushing against
the collar on the left side. Disconnect wire harness.
E. Remove 2 screws holding top hinge to the case.
Carefully lift off door.
Follow the same procedure to remove the fresh food
door.
NOTE: To prevent damage, leave inside
packaging, door spacer and outside
protective wrap in place until the unit is
moved to the installation location.
Hinge Screws
E
Water Line Coupler Wire Harness
D
Toekick Screw
C
B
A