GIGABYTE Rack Mount Server GS-SR125EDL - Manual (Page 11)

11
Hardw are Installation Process
Chapter 2 System Hardware Installation
Please observe the safety information in chapter ¡§ Important Safety Information¡¨
Do not expose the server to extreme environmental conditions. Protect it from dust, humidity,
and heat.
Step 2-1: Chassis Removal
Step 2-2: CPU Installation
Step 1 Push down the two buttons located at two sides of the chassis.
Step 2 And slide toward to remove the top cover.
After removing the top cover, you can install CPU and other essential components.
Step 1 To install the CPU(s), lift up the bar that located next to the socket.
Step 2 The noticed corner should point toward the end of lever. The CPU will only it in the orientation
as shown below.
Step 3 Then, align the CPU and insert it into the socket.Then, push the lever to the original position.
Please make sure the CPU type and speed that are supported by the motherboard.
Step 1 Step 2
Step 1
Step 2
Push Toward