Globe 3850 - Manual (Page 10)

Page 11
AUTOMATIC SLICER OPERATION
BEFORE beginning to use the slicer for automatic slicing, MAKE SURE the auto engage
lever is in the “Manual” position.
Automatic slicer operation: NEVER put hand into chute arm opening on right side of
slicer. Keep hands and arms away from all moving parts.
1. Make sure the slicer is turned off (power indicator light not illuminated). Make sure auto engage
lever is in “Manual” position and that the food chute moves freely.
2. Pull the food chute completely towards you and load the food product. Swing the end weight into
position to secure food product.
3. If the food product is too long, place the end weight on top of the food product and use the end
weight prongs to hold the food product in place.
4. Auto engage lever must be in “Manual” position to start the slicer.
5. Press the start button. The power indicator light will illuminate. If the speed light is flashing, then
the auto engage lever is in the “Automatic” position. Press the stop button to turn off the machine.
Lower the auto engage lever to the “Manual” position and restart the unit.
BE ALERT. The next step will cause the food chute to move automatically and it can move
either direction on start up.
6. To make the food chute move automatically, pull or raise the auto
engage lever into the “Automatic” position (Fig. 11-1).
a. Model 3850 – To adjust the chute speed press the faster button for
60 strokes per minute and the slower button for 40 strokes per
minute.
b. Model 3975 – To adjust the chute speed press the slower or faster
buttons. The slicer defaults to speed 5 when the power cord is
unplugged and plugged back in. If the slicer is turned off but not
unplugged, it will return to the last speed used.
NEVER attempt to adjust, load or unload food chute when slicer is in automatic operation.
NOTE: Chute speed can be adjusted prior to or after auto engagement.
AUTOMATIC OPERATING INSTRUCTIONS
Figure 11-1
Auto Engage Lever