Gold's Gym Maxx Crosswalk 650 User Manual

Page 10

1. Remove the key from the console and unplug

the power cord.

Remove the indicated #8 x 3/4" Screw (3) and

the Access Door (76) from the back of the

Console Base (85).

2. Connect the wire on the receiver (A) to the indi-

cated wire extending from the Console Base

(85). Hold the receiver so that the small cylin-

der is oriented as shown and is facing the

Console Base. Attach the receiver to the plastic

posts on the Access Door (76) with the two in-

cluded small screws.

3. Make sure that no wires are pinched. Reattach

the Access Door (76) with the #8 x 3/4" Screw

(3). Discard the other wires included with the re-

ceiver.

If you purchase the optional chest pulse sensor (see page 21), follow the steps below to install the receiver

included with the chest pulse sensor.

Small

Cylinder

Wire

Small

Screws

10. Locate the Latch Pin Assembly (21). Remove

the knob from the pin. Make sure that the collar

and the spring are on the pin. (Note: If there are

two collars, place one on each side of the

spring.) Next, insert the pin into the Latch

Housing (73). Then, tighten the knob onto the

pin.

Spring

Collar

Knob

11. Make sure that all parts are properly tightened before you use the treadmill. If there are sheets of clear

plastic on the treadmill decals, remove the plastic. To protect the floor or carpet, place a mat under the tread-

mill. Note: Extra hardware may be included. Keep the included hex key in a secure place; the hex key is used

to adjust the walking belt (see pages 26 and 27).