Controls – Grizzly G5352 User Manual

Page 8

Model G5352 Spray Gun

-8

2. Screw the cup onto the top of the

body.

3. Attach the air hose directly to the air fit-

ting on the spray gun or with a

⁄

" NPT

quick connect fitting (not included).

4. Attach the spray gun to a filtered, regu-

lated air source. See the

Tool Data

Sheet on Page 8 for your spray gun air
requirements.

Note: For the best results, use a hose
that will be dedicated for spray use
only. Do not use a hose that has been
used with an in-line oiler or other pos-
sible contaminant.

If you need additional help with this assem-
bly, call our Technical Support at: (570)
546-9663.

1. Fluid Control: Controls the volume of

material that travels through the fluid
tip.

2. Pattern Control: Adjusts the spray

pattern from a round pattern to a wide
fan.

3. Air Flow Control: Controls the fluid

pressure inside the spray gun.

4. Atomizing Cap: Controls the spray

pattern from vertical to horizontal.

5. Trigger: Two stage trigger. Stage

one only releases compressed air for
blowing off the work piece. Stage two
sprays material. Lightly squeeze the
trigger for stage one. Squeeze the
trigger all the way to spray.

Controls

Figure 3. Controls.

Fluid Control

Pattern Control

Atomizing Cap

Trigger

Air Flow Control